11
(ENG) VQT4Q07
Button Functions
[ SL AUTO] The flash can be fired remotely in sync with any
flash fired by other units.
[SL AUTO]: Flash level is set automatically.
[SL MANUAL]: The flash fires at the selected guide
number.
[ SL MANUAL]
Button Function Use
[]
Adjust flash level by up to w5 EV.
This value is combined with
adjustments to flash
compensation made using the
camera.
1 Press [ ] (2) or [ZOOM]
(4).
2 Rotate the dial to select the
value, and then press the
[OK] button.
[ZOOM]
Adjust the lighting angle manually.
[M] appears in the display.
[]
Manually turn the LED light on or
off.
1 Before shooting, set the
LED light to [M].
“Other Settings” (P13)
2 Press [ ] (1) to turn the
LED light on. Press [ ] (1)
again to turn the LED light
off. To view the LED
brightness setting, press
and hold [ ] (1) for 2
seconds while the LED light
is on.
≥ The flash and batteries may
become warm if you keep the
LED light on, but this is not a
malfunction.
[
TEST/
CHARGE
]
To fire a test flash, press the [TEST/CHARGE] button while the [TEST/
CHARGE] lamp is lit.
[BACK
LIGHT]
The control panel backlight lights for about 15 seconds.
Control panel display Control operation
VQT4Q07_PP_E_GK.book 11 ページ ２０１２年１０月２３日 火曜日 午前９時３９分
To Next Page
Loading...