VQT4Q07 (ENG)
8
Preparing a Battery (optional)
Choose from the below batteries:
≥ LR6/AA Alkaline dry batteries (x 4)
≥ HR6/AA Rechargeable nickel metal hydride batteries (Ni-MH) (x 4)
The use of batteries made by Panasonic is recommended.
Loading Batteries
≥ Use alkaline dry batteries or rechargeable nickel
metal hydride batteries.
1 Slide the battery cover to open it.
2 Insert the batteries with correct [r]/
[s] polarity.
3 Close the battery cover by sliding it
back firmly as far as it will go.
Attaching to the Camera
Confirm that both the camera and flash are off. Attaching or removing the flash
while either the flash or the camera is on may result in malfunction.
1 Slide the lock lever in the direction
opposite to that indicated by the
[LOCK 1] icon (1).
2 Slide the flash into the hot shoe until
it clicks securely into place (2).
3 Slide the lock lever to the [LOCK 1]
position (3).
≥ To remove the flash, slide the lock lever in the direction opposite to the [LOCK1]
arrow and slide it from the shoe.
Turning on the Flash
Attach a flash to the camera, and then turn the camera on.
R6/AA Manganese dry batteries cannot be used.
1 [AUTO CHECK] lamp
2 [TEST/CHARGE] lamp
3 Control panel
4 [ON/OFF] button
VQT4Q07_PP_E_GK.book 8 ページ ２０１２年１０月２３日 火曜日 午前９時３９分
To Next Page
Loading...