10
VQT3M28
Preparation -Setting the O-ring-
Be sure to set the O-ring before attaching a digital camera.
Thoroughly wash and dry your hands before handling the O-ring. Place
the O-ring where there is no sand or dust.
1 Loosen the O-ring with your fingers to remove it.
≥
Loosen part of the O-ring with the tips of two fingers and then lift the loosened
part. Be careful not to scratch the O-ring with your fingernails.
∫ Note
≥
Do not use a pointed object to remove the O-ring. This may scratch or damage the
O-ring.
DMW-MCTZ20-VQT3M28.book 10 ページ ２０１１年１月１３日 木曜日 午前１０時６分
To Next Page
Loading...
