16
VQT3M28
Preparation -Attaching the Digital Camera- (continued)
≥ When inserting the silica gel, bend it as shown in the illustration below
and then insert it as far as possible. If you close the Case with the silica
gel not fully inserted, the silica gel will get caught in the O-ring causing
water leakage.
≥ If the air temperature is high and the water temperature is low, condensation
may appear inside the Case. To prevent condensation, insert silica gel
(supplied) inside the Case in advance. To prevent the Case from becoming
fogged up, insert the silica gel about 1 to 2 hours before using the Case.
4 Close the buckle.
‘
Check that the buckle is closed firmly.
Do not insert the strap etc. in the buckle.
5 After you have attached the digital camera, check one more time that
no water leaks into the Case. (P14)
DMW-MCTZ20-VQT3M28.book 16 ページ ２０１１年１月１３日 木曜日 午前１０時６分
To Next Page
Loading...
