Troubleshooting
No sound
Check the Audio or video connection between the DVD player and the TV. (example; composite
red and white audio cables, HDMI cable)
Turn on your TV and set the TV to the correct input the DVD player is connected to on the TV.
During playback of DTS source, there will be no sound from the speakers. Select a different
audio source (e.g. Dolby Digital). (for DVD-S700 model only) or please connect the unit to an AV
receiver that can decode DTS via an HDMI terminal, and set “Audio Out” to “Bitstream". See
How to set Audio Out to Bitstream or PCM.
Audio Out sets the audio output method when connected to the “HDMI AV OUT” terminal.
1. Press [SETUP].
2. Press [▲]/[▼] to select "AUDIO, and press [►].
3. Press [▲]/[▼] to select "Audio Out" and press [►] to confirm your selection.
4. Press [▲]/[▼] to select "Bistream" or "PCM"and press [OK].
o To return the previous menu, press w.
o To exit, press [SETUP].
Note:
Select Bitstream when the connected equipment is supporting Dolby Digital.
Select PCM when the connected equipment is not supporting Dolby Digital.
Messages on the screen - "Cannot read. Please check the disc."
An incompatible disc is inserted. (Video CD, etc).
Messages on the screen - "Cannot read. Please check the disc."
An incompatible disc is inserted. (Video CD, etc).
Messages on the screen - "No disc inserted."
The disc may be upside down.
Messages on the unit’s display - "NO READ"
The media is dirty or badly scratched. The unit cannot play.Try another disc and confirm if the disc plays.
If the player is unable to play all the discs, then it will require service. Press and hold [OPEN/CLOSE] to
eject disc.
Forgot the rating levels password. - DVD-S700, DVD-S500
To Next Page
Need help?
General
