16
Pore‑targeted cleansing
We recommend this option for rough or clogged areas
such as the nose and chin. After completing the brush
cleansing process, continue to use this option while the
foam is still on your skin.
1
1
Attach the pore focus brush.
2
2
Press the facial cleanse switch and
select a mode.
• Wash off any excess facial cleanser on
your hands.
3
3
Wash your face.
3
1
2
Do not press the bristles of the
pore focus brush into your skin.
Lightly apply the brush to your
skin so that the bristles just touch
the skin and then wash your face
in a circular motion.
• Wash your nose and chin (
– ) for approximately
20 seconds each.
(Notication timer feature (See page 15.))
• Do not use the brush around your eyes.
• Do not apply the appliance to the same area for
extended periods of time.
• The appliance may stop automatically for its own
protection if the foam inside it is too thick. Please
rinse the inside of the appliance lightly before using
the pore focus brush.
4
4
After you have nished washing your face, press
the facial cleanse switch to turn off the power.
• Make sure to wash the appliance after use.
• The power will be automatically turned off
approximately 1 minute after the power is turned
on.
Cleaning
1
1
Rinse foam off the brush with water and then
remove.
2
2
Open the facial cleanser
compartment cover, begin
pouring water into the foam
dispenser, and then press the
facial cleanse switch to rinse.
• If a signicant amount of facial
cleanser remains, the power
may turn off a few seconds after
pressing the facial cleanse
switch or may not operate
smoothly. In such cases, use
warm water to clean and remove
the excess cleanser.
3
3
Press the facial cleanse switch to turn off the
power.
PB017051 - EH-XC10 ������_(01EN)_11-19-18.indd 16 2018/11/19 8:41:32
To Next Page
Loading...
