Panasonic Elite Big PAC-i U-250PZH2E8 - Page 242

6-4
66
LED
A
A
A
Fig. 6-1
Fig. 6-2
Fig. 6-3
l
All units start/stop (Fig. 6-1)
<Operation>
The (Start/Stopoperation)buttoncanbeused
to start and stop all the indoor units.
 •TheLEDilluminatesifanyindoorunitsisoperating.
 •TheLEDblinksifanalarmatanyoftheoperatingindoor
units occurs.
l
Cooling/heating change (Fig. 6-1)
NOTE
Cooling and heating mode changes are only available
when all indoor units are stopped.
<Operation>
The
A
(Mode) button can be used to change
between heating and cooling operation.
 •Thedisplayindicatestheoperatingmodeoftheindoor
unit with the lowest unit No.
l
All units test run (Fig. 6-2)
<Operation>
The (Check) button can be used to start and stop a
test run for all indoor units.
 •Pressandholdfor4secondstoturnON.
During the test run “
” is displayed.
 •Thestatusoftestrunsperformedfromtheindoorunit
remote controller is not displayed on the outdoor unit
maintenance remote controller.
l
Double-speed (Fig. 6-3)
 •Donotuseforactualoperation.
(Doing so may damage the devices.)
<Operation>
The timer button
can be used to change between
double-speed and normal operation.
 •Duringdouble-speedoperation,theSleepingMode
mark is displayed.
SM830276-00_欧州向け R32シングル TD＆SM.indb 4 19/02/12 15:38:55