Panasonic Elite Big PAC-i U-250PZH2E8 - Page 280

88
Indicator lamps
When an error occurs, one of the
lamps flashes. When an indicator
lamp is flashing, refer to
“Troubleshooting”.
CZ-RWSC3
CZ-RWRC3
Front side
Rear side
1 2 3 4
1
2
3
4
5
6
7
ADDRESS 1
ADDRESS 2
ADDRESS 3
REM SUB/MAIN
CZ-RWSU3
CZ-RWRU3
1
2
3 4 5
1. Receiver
Receives the signal sent from the
remote controller.
Lights up when the unit is operating.
2. Emergency
operation button
See page 8-11.
The lamp in the HEAT mode lights
up at the following times: during
the startup, during the thermostat
operation, and during the
defrosting.
5. STANDBY lamp
3. OPERATION lamp
Lights up when the timer is set.
4. TIMER lamp
See the section “8-9. Pairing
Addresses” on page 8-9.
7. Address switch
6. FILTER lamp
This lamp is for notifying you when
the filter needs to be cleaned.
RECEIVER
Screen display
1
2
3
6
8
9
10
11
57
12
4
13 14 15
1 Appears when ECONAVI is being
set to ON.
2 Indicates the set temperature.
3 Appears when nanoe™ X is being
set to ON.
4 Displays the present time.
5 Timer program indication
: The indoor unit starts
operation at the programmed time.
: The indoor unit stops
operation at the programmed time.
6 Indicates the remote controller
addresses are set.
7 Appears when the function is not
available.
8 The ON timer or the OFF timer
will operate repeatedly every day.
9 Indicates the
position.
10
Indicates the fan speed.
11 Displays the selected operation
mode. (AUTO
/HEAT /
DRY
/COOL /FAN )
12 Energy saving operation is in
process.
13
Appears when a fan available in the
market is installed and is operating.
14 “Temperature Automatic
Return”
is set.
15
Appears when the setting screen
is displayed.
8-4
SM830276-00_欧州向け R32シングル TD＆SM.indb 4 19/02/18 11:16:03