1-11-5
1
<Type E3>
<Type U2>
Insulation tape
8 mm
Insulation tape
Shield mesh
Shield mesh
Examples of shield wires
Earth wire for power supply
(1) Remove cable coat not to scratch braided shield.
(2) Unbraid the braided shield carefully and twist the
unbraided shield wires tightly together. Insulate the shield
wires by covering them with an insulation tube or wrapping
insulation tape around them.
(3) Remove coat of signal wire.
(4) Attach ring pressure terminals to the signal wires and
the shield wires insulated in Step (2).
The earth wire should be longer than the
other lead wires for electrical safety.
Wiring samples
Power
supply
Ground terminal fixing for
(
: Functional earthing)
Inter-unit control
wiring
Earth wiring:
Make the earth wiring 25 - 30 mm longer
than power cable.
Remote control
wiring
Power cable
Clamper (supplied)
Use this screw when connecting the shield
for the Inter-unit control wiring to ground.
(
: Functional earthing)
*1 Fasten tightly.
Earth Wiring:
Make the earth wiring 25 - 30 mm longer than power
cable.
Power Supply
Power cable
Inter-unit Control
Wiring
Clamper
*
1
(supplied)
Clamper
*
1
(supplied)
Clamping
Clip
Remote Control
Wiring
SM830276-00_欧州向け R32シングル TD＆SM.indb 5 2019/02/27 11:54:23
To Next Page
Loading...
