Always use on a flat surface.
Failure to do so may result in the unit tipping over,
causing an accident.
The unit should not be used on top of heating
appliances, such as electric carpets, etc.
Doing so may cause fire.
● Ensure there is adequate space to recline.
● Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of
heating sources, because this can cause discoloration or hardening of the synthetic leather.
● Place the unit on a mat to prevent floor damage.
When placing a mat under the unit, the size
of the mat should be sufficient (at least 120 cm × 70 cm) to cover the areas where the unit
touches and where the legrest could touch the floor, as shown in the diagram on the above.
● Install the unit near a power outlet.
● For details on the dimensions of the unit, see
page 59.
Area where legrest
could touch the floor
Area where unit
touches the floor
Mat
Keep at least 10 cm away from the wall.
Approx. 202 cm
Approx.
30 cm
Width approx. 90 cm
Approx.
49 cm
Setting up the massage lounger
Main unit
Accessories
●
Armrests (Right/Left)
Right/Left indication
(Back of the armrest)
Controller
●Allen key — 1
This is initially inserted
in the lock switch of the
power switch section
prior to leaving the
factory.
●Lock switch key
●Attachment screws
(M6 × 13) — Black
(M6 × 29) — Silver
●Comfort
cushion
●Power cord
●Pillow
●Controller stand
Controller
holder
(2 pcs.)
(4 pcs.)
Controller
holder fixing
screw
Clip
The holes in the fabric
at the back of the
hand & arm massage
section are due to
the manufacturing
process and are not a
fault.
2
Confirm that the main unit and the accessories are in the box.
To Next Page
Loading...
