20
5
5
Put the scrub brush onto your
skin and begin exfoliation.
•We recommend using on legs, arms
(especially elbows and knees) and
neckline.
Do not use on sensitive areas of skin
or face.
•Do not continue to hold in one place.
Slide over skin in a circular pattern.
•Apply to the same area of skin for
approximately 30 seconds each time,
check your skin and adjust usage
accordingly.
6
6
Moisturise by applying a moisturiser that suits
your skin on the area where the scrub brush was
used.
Cleaning
•Always clean the heads and caps after use to keep them in a
hygienic state.
•Switch off and unplug the appliance before cleaning.
•Take care not to damage the skin protector, the frame, the fast
cap and the gentle cap during cleaning.
Dry cleaning [BCDFH]
Epilation head/Shaver head
1. Lift fast/gentle caps,
the frame upward while
holding the cap release
rib [BC2]/the frame
release rib [F6] or
remove the frame by
pushing the frame
release button [H].
2. Clean the gentle cap [C], the
epilation head [D, F] and the
shaver head [H] with the
cleaning brush [].
Wet cleaning [BCDFHJL]
Epilation head/Shaver head
1. Wet the discs and blades, and then apply
liquid hand soap.
2. Turn the switch on and then foam is
created.
To Next Page
Loading...
