Panasonic ES-MT22 - Cleaning and Maintenance; Cleaning the Shaver

52
English
Operation and display of the switch lock
►Locking the power switch
1. Press once
and then release.
• The shaver
starts
operating.
2. Hold for more
than 2 seconds
until the switch
lock lamp (
)
turns on.
• The shaver will
stop operating.
3. Release .
• The switch
lock lamp
(
) will
light up for
5 seconds
and turn off.
►Unlocking the power switch
1. Hold for more than
2 seconds until the
switch lock lamp (
)
turns off.
2. Once the shaver starts
operating, release
.
• The switch lock lamp
(
) will turn off.
• The power switch is locked when the switch lock lamp
(
) blinks for 5 seconds and the shaver does not
operate even though the power switch is pressed.
• While the shaver is locked, the shaver cannot be
operated and the lamps do not glow even if
is
pressed.
Cleaning the shaver
We recommend cleaning the shaver after each use.
Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and some
water to the system outer foil and
ion plate�
2
Hold for more than
2 seconds to activate the sonic
vibration cleaning mode�
• The switch lock lamp (
) and
charge status lamp (
) blink
alternately.
• After about 18 seconds, it will be
automatically turned off, or you can turn it off by
pressing the power switch.
3
With the shaver stopped, remove the outer foil
section and hold
for more than 2 seconds�
• See page 54 for removing the outer foil section.