Panasonic ET-DLE035 - Page 11

ENGLISH-11
z
When using one of PT-DZ870 / PT-DW830 / PT-DX100
When moving the lens position to the lens standard position, perform the operation with the following procedure.
1) Turn on the projector to start the
projection.
2) Press the <MENU> button to dis-
play the [MAIN MENU] screen.
3) Select [PROJECTOR SETUP] in
the main menu and then press the
<ENTER> button.
4) Select [SERVICE PASSWORD] in
the [PROJECTOR SETUP] menu
and then press the <ENTER> but-
ton.
z
The[SERVICEPASSWORD]inputscreen
appears.
5) Use the <0> and <3> numeric
buttons on the remote control to
enter “030” in the [SERVICE PASS-
WORD] input screen and then
press the <ENTER> button.
z
The[DLE030POSITION]screenappears.
6) Press the <ENTER> button on the
[DLE030 POSITION] screen.
z
[PROGRESS]isdisplayedonthe[DLE030
POSITION]screenandthelensposition
moves to the standard position for
ET-DLE035.
Note
z
After returning the lens to the standard projection position, lens shift adjustments are possible within the range
where the projector will not interfere with the edges of the projected image.
z
If the rear of the projector blocks the bottom edge of the projected image, it may also obscure the view of an
On-screen display (OSD) that is positioned at the lower edge of the screen. If this happens, open the [DISPLAY
OPTIONS]menuandselect[ON-SCREENDISPLAY]
→
[OSDPOSITION]tochangedisplaylocationsothat
the whole OSD menu can be seen.
LAST USED
SW1234567
ET-LAD120
DISABLE
DEFAULT
1.00
1.00
ACTIVATED
2/2
PROJECTOR SETUP
STARTUP INPUT SELECT
RS-232C
STATUS
NO SIGNAL SHUT-OFF
REMOTE2 MODE
FUNCTION BUTTON
DATE AND TIME
LENS CALIBRATION
SAVE ALL USER DATA
LOAD ALL USER DATA
INITIALIZE
SERVICE PASSWORD
LENS
DLE030 POSITION
OK
CANCEL
MENU
ENTER
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
3D SETTINGS
PROJECTOR SETUP
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU
P IN P
ENTER
Lens position setup and focus adjustment (continued)