Panasonic ET-DLE035 - Projection Relationships

ENGLISH-7
The dimensional relationship between the screen and the projector is shown below.

Dimensional relationship diagram
SH
SW
SD
SH
A1
L3
L4
A2
L1
L2
Projected image
Screen
Note
z
The indications of this illustration are premised on aligning the projected image size and position to the full screen.
z
This illustration is not drawn to scale.
SH Projected image height L3 Screen to projector front end
SW Projected image width L4 Screen to projector rear end
SD Diagonal length of the projected image
A1
Bottom edge of the screen to the top of the
projector
L1
Projection distance
(fromscreentomirrorreective surface*)
A2
Bottom edge of the screen to the bottom of the
projector
L2 Screen to lens front end
*Themirrorreectivesurfaceisinsidethexed-focuslens,andisnotvisiblefromtheoutside.
Note
z
Theillustrationsofprojectorsinthismanualareforinformationalpurposesonlyanddonotrepresentaspecic
projectormodel.Congurationsmayvarywiththemodel.
z
Dimension L4 is the distance from the projector rear panel to the screen.
z
Dimension A2 is the distance from the bottom edge of the screen to the bottom of the adjustable projector legs
(with the legs fully screwed in).
Attention
z
Dimension L4 is not the distance from the projector rear panel to a wall, but the distance from the projector
rear panel to the screen. To prevent obstruction of the intake and exhaust vents, install the projector with a
clearance at least 500 mm (19-11/16") from walls and objects.
 Whenplacingtheprojectorinaconnedspace,aventilationand/orairconditioningsystemisrequired.
 Exhaustheatmayaccumulatewhentheventilationisnotsufcienttriggeringtheprotectioncircuitofthe
projector.
● Avoidsettingupinplaceswhicharesubjecttosuddentemperaturechanges,suchasnearanairconditioner
orlightingequipment(studiolamps,etc.).
Projection relationships