Panasonic EW-DJ4B - Operating the Oral Irrigator; Nozzle Installation and Water Tank Filling

English
2
Forsafetyandenergysaving,
disconnect the power plug after
chargingiscompleted.
• Disconnect the appliance plug from the charging
socket, and then close the charging socket cover.
• To keep charging the battery will not a󰀨ect
battery performance.
Operating time after a full charge
approx.10minutes*
(When the water pressure level is set to 4)
* It varies with the ambient temperature and usage
conditions.
• Charging is completed after approx. 1 hour.
(The charging time may vary with the remaining
battery capacity.)
Notes
• The charging time may di󰀨er when the appliance is
used for the rst time, or if it has not been used for
more than 6 months.
In addition,
(the charge status indicator) may not
light on in the rst several minutes of charging, but it
will light on as the charging proceeds.
• The recommended ambient temperature for charging
is 10 °C - 35 °C. It may take longer to charge, or
will ash rapidly and the battery may fail to charge
properly in extremely high or low temperatures.
How to use
1
Pulloutthemainbodywhile
rotating it, and then install the
nozzle.
a

Open the water tank cap.
• If it is closed, the main body
is hard to be pulled out.
b

Pull the main body to the "
" mark.
• Be noted that the nozzle
may be ejected from the
nozzle storage unit.
c

Install the nozzle while
holding the main body.
• Install it into place until it
clicks.
❸
❶
❷
click
2
Fillthewatertankwithwater.
a

Add water while keeping the
main unit level.
• Do not ll beyond the
full-water position.
b

Close the water tank cap
securely.
• Always use new tap water or
lukewarm water.
• If you feel the water is cold,
use lukewarm water with a
temperature of 40 °C or less.
Full-water position
12
EW-DJ4B EU0713.indb 12 2022/7/14 下午1:40