Panasonic EW1614 - Important Information; Parts Identification

10
English
Important information
►Notice
• Do not put salt, mouthwash or other chemicals into the
water tank. Doing so may cause malfunction.
• Do not dry the main unit with a dryer or a fan heater.
Doing so may cause malfunction or deformation of the
parts.
• Store the appliance in a place with low humidity after
use. Failure to do so may cause malfunction.
• About tooth tartar
Please use together with a toothbrush.
It is hard to remove tooth tartar or dental calculus
attached to the tooth surface just by a water jet, so a
toothbrush is required to brush the teeth.
It is recommended to clean inside your mouth with the
water jet after brushing your teeth.
• About bleeding gums
Initially bleeding may occur even with healthy gums.
This is caused because the gums are not used to such
stimulation. The bleeding will normally stop within
1 or 2 weeks of use. There may be a problem with
the gums (periodontal disease, etc.) if the bleeding
continues for over 2 weeks. In such cases, stop using
the appliance andconsult a dentist.
Partsidentication
A
Handle
1
Stop/Jet switch
2
Jet mode “
”
3
Stop mode “
”
4
Nozzle release button
5
Nozzle
B
Main unit
6
Cord
7
Power plug
8
Suction hose
C
Water tank
9
Upper water level limit

Water tank cap
D
Operation panel

Water pressure
level LED indicator
(1~10 levels)
(Level 1 is also the
Child mode “
”.)

Power switch “
”

Water pressure
regulator switch
E
Ultrasonicnozzle(x2)
q
Nozzle
w
Nozzle insertion port
F
Orthodontic nozzle
q
Nozzle
w
Nozzle insertion port
e
Identication ring
r
Nozzle Handle
G
Tongue care nozzle
q
Nozzle
w
Nozzle insertion port
e
Identication ring
t
Cloth
• All of the nozzles are
consumables.
Accessory
H
Nozzle stand
There may be moisture inside the main
unit (water tank and suction hose) left
from the distilled water used for product
testing.
■
Iftheidenticationringcomeso󰀨
(For orthodontic nozzle and
tonguecarenozzleonly)
Align the identification ring (in any
direction) with the nozzle, and
attach them without any inclination.
• Even if the identication ring is
not attached, it does not a󰀨ect the
performance of the nozzle.