Panasonic EW1614 - Troubleshooting

16 17
English
Troubleshooting
Problem Possible cause Action
No water comes out, or the water
jet power is weak.
TheStop/Jetswitchisleftin“ ” (stopmode)whilethepowerison.
→Take the following steps:
a
Fill the water tank with water halfway.
b
Press the power switch “ ” to turn on the power and press “+” to set
the water pressure level 10.
c
Set the Stop/Jet switch to “ ” (jet mode).
d
Insert and remove the water tank for several times.
e
Install the water tank and wait for a few seconds until the water pressure
is restored.
* Repeat Steps
d
and
e
if the water pressure is not restored.
• Once the water pressure is restored, you can use the appliance as usual.
The nozzle is clogged.
Replace the nozzle.The outlet of nozzle is squashed.
The nozzle comes o󰀨 during use. The nozzle is deformed.
Fail to remember the water
pressure level.
The power plug is pulled out from the household outlet
before the power switch “
” is turned o󰀨.
Before pulling out the power
plug from the household outlet,
turn o󰀨 the power switch “
”.
Motor sound changes after the Stop/
Jet switch is set to “
” (stop mode).
This is not an abnormality. →Please use the appliance as usual.
* It may occur particularly in a low-temperature environment.
The power is cut o󰀨 automatically.
The function for avoiding forgetting to turn o󰀨 is
activated.
This is not an abnormality.
(See page 11.)
The self-protection function is activated due to a
thunderstorm etc.
Turn on the power switch “ ”
again.
The water pressure level LED
indicator still ashes after the
power switch “
” is turned o󰀨.
This is not an abnormality.
→The indicator will go o󰀨 after 30 seconds. (See page 14.)
The nozzle is hard to install.
→Apply water to the nozzle insertion port.
If the problems still cannot be solved, contact the store where you purchased the unit or a service centre authorized by Panasonic for repair.
d
e
b
While using
Press