Panasonic EW3002 - Name and Function of Each Product Part

87
Inserting/Replacing Batteries
1. Grasp the battery cover and remove it to the left as shown in Fig. 2-a.
2. Insert two 1.5 V alkaline (AAA/LR03) batteries, observing the (+) and (-)
signs to ensure correct polarity.
3. Close the battery cover until it clicks into place (Fig. 2-b).
• Approximately 500 measurements can be taken with a new set of
Panasonic alkaline batteries (at an ambient temperature of 22°C
(71.6°F), pressurization of 180 mmH ).
Fig. 2-a Fig. 2-b
Notes:
• Do not mix old and new batteries.
• The batteries’ power output is impaired at low temperatures.
• The performance of the batteries included with the product may be
affected somewhat according to factors such as the amount of time past
since the date of manufacture.
1
2
S
Y
S
.
m
m
H
g
D
IA
.
m
m
H
g
P
/
m
in
.
R
On/Off
Start
P
R
E
C
IS
E
L
O
G
IC
™
PRECISE LOGIC
™
S
Y
S
.
m
m
H
g
D
I
A
.
m
m
H
g
P
/
m
in
.
R
On/Off
Start
3
Name and Function of Each Product Part
S
Y
S
.
m
m
H
g
D
IA
.
m
m
H
g
P
/
m
in
.
R
On/Off
Start
Battery cover
Pressure cuff
Fig. 1
Start (On/Off) button
Hard carrying case
(Can be used as an armrest)
R
On/Off
Start
SYS.
mmH
DIA.
mmH
P/ min.
Recall button
Display
When to Change Batteries
Change the batteries when the battery symbol
(Fig. 3) appears on the display or when no data
is displayed even when the On/Off button is
pressed.
CAUTION:
Do not throw batteries into a fire. Doing so
may result in an accident or explosion.
R
On/Off
Start
SYS.
mmH
DIA.
mmH
P/ min.
Fig. 3
EW30022002.12.1211:49AMページ7