Panasonic EW3109 - Hypertensive Reading Alerts; Troubleshooting Measurement Errors

Taking a Reading
Measurement
On/Off
1. P ress the On/Off Start button.
• The pressure cuff will automatically be pressur¬
ized and a measurement will be taken.
SYSTOLIC
nmHg DIASTOLIC mmHg
000
000
!_/ III I m hi SO
000 VI8EI
pulse/min.
SYSTOLIC
nmHg DIASTOLIC mmHg
in o
IUO
pulse/min.
The entire display will light for approximately
1 second.
• If there is air left in the pressure cuff, the
fully lit time will be longer.
The heart mark V will blink when pulse is
detected during pressurization.
C I ^
In the process of pressurization, changes in
pressurization speed and operating sounds
are normal and necessary for the purpose
of measurement during pressurization.
2. W hen measurement has been completed, the
blood pressure and pulse values will be displayed.
• Pressure will be automatically released
from the pressure cuff.
• If the measured value is in the high
blood pressure region, the values will
blink (for approximately 6 seconds).
(For how to read the blood pressure
display, see p. 16.)
The CM] mark will blink. (For storing measure¬
ment values, see p. 17.)
The pulse rate value is the beats per minute
calculated based on the pulse rate during
measurement.
3. T o switch off the blood pressure monitor, press
the On/Off Start button.
• If you forget to switch it off, the blood pres¬
sure monitor will switch off automatically after
approximately 5 minutes.
15