1 1
turn on the unit. turn on the unit.
Select the air direction. Select the air direction.
Press [Dry Clothes] to select
the operating mode.
Press [Dehumid.] to select
the operating mode.
3 3
2
● The dehumidifying louver will
open automatically and the unit
will start to operate in “Medium”
mode. (The “Med” indicator
and the Humidity indicator will
illuminate.)
● The dehumidifying louver will
open automatically and the unit
will start to operate in “Medium”
mode. (The “Med” indicator
and the Humidity indicator will
illuminate.)
● The fan may continue to
operate for approximately 2
minutes after the dehumidifier
has been turned off in order to
cool down the inside of the unit.
→Wait 2 minutes or more after
turning off the dehumidifier
before disconnecting the
power plug.
● The fan may continue to
operate for approximately 2 minutes
after the dehumidifier has been turned
off in order to cool down the inside of
the unit.
→Wait 2 minutes or more after
turning off the dehumidifier before
disconnecting the power plug.
●
Operation will stop automatically.
→Empty the water from the tank (page 13).
●
Operation will stop automatically.
→Empty the water from the tank
(page 13).
● The direction can also be adjusted using the flap. ● The direction can also be adjusted using the flap.
(When not using “Eco (Auto)” or “Hi (Auto)”)
● If no buttons are pressed for 24 hours, operation will stop automatically to prevent the dehumidifier from
staying on too long.
● If no buttons are pressed for 24 hours, operation will
stop automatically to prevent the dehumidifier from
staying on too long.
● Keep dry operation: Humidity is maintained at
approximately 45% to prevent it from increasing again.
● The actual state of dryness may vary depending on
factors such as the type and amount of clothing, the
hanging method, and environmental conditions.
Note
Note
● The Intelligent dryness monitoring system will illuminate
during “Eco (Auto)” and “Hi (Auto)” operation, and the ECO
indicator will also illuminate during “Eco (Auto)” operation.
● Automatic stop (page 18)
(The indicator illuminates.)
(“Eco (Auto)” and “Hi (Auto)”
operation only)
Dryness notification
When dehumidifying
2
Med
Hi
Auto
Lo
Insert the power plug into a wall socket and Insert the power plug into a wall socket and
pages
10,11
pages
10,11
Air Swing button and indicators
Dehumidify button and indicators
(The indicator illuminates.)
●
To automatically maintain humidity
at a comfortable level (approx. 55%)
● To remove humidity quickly
● To dehumidify quietly