EasyManua.ls Logo

Panasonic F3 - Maintenance and Operation Insights; Maintenance Safety and Operation Modes

Panasonic F3
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Operation Mechanism
Heating performance
This air conditioner utilizes outside air for heating; its
heating performance reduces as outside temperature
decreases.
In the event that heating is not sufcient, please use an
additional heating appliance.
Defrosting
This appliance may start defrosting operation to melt
frost formed in the outdoor unit.
Defrosting starts
: The indoor unit fan stops (or the
speed becomes extremely slow).
→“
” (STANDBY) appears.
Heating operation resumes after several
minutes
: The indoor unit fan remains stopped (or
it will run at a very slow speed) until the indoor heat
exchanger coil warms up sufciently.
→ “
” (STANDBY) appears.
Defrosting is complete
: The indoor unit fan starts
operation.
→ “
” (STANDBY) disappears.
‘DRY’ operation
Once the room temperature reaches the level that was
set, the outdoor unit repeats the cycle of turning on and
off automatically.
When the room temperature is more likely to reach the
level that was set, the fan speed is set to ‘‘breeze’ (light
wind) automatically.
Should power failure occur while the unit is
running
The unit will resume operation automatically. Operation
settings prior to power failure will be used.
WARNING
For safety, be sure to turn the air conditioner off and
disconnect the power before cleaning. (Otherwise,
electric shock or injury may result because the fan is
rotating at high speed.)
Do not pour water on the indoor unit. (This may damage
the internal components and cause an electric shock
hazard.)
CAUTION
Never use solvents or harsh chemicals. Also, do not
wipe plastic parts using very hot water. (This may cause
deformation or change in colour.)
Some metal edges and ns are sharp. Be careful when
you clean those parts. (Injury may result.)
Use a rm stool or ladder when cleaning an indoor unit
installed in high locations.
Maintenance
The internal coil and other components of the outdoor unit must be cleaned periodically.
• Consult your dealer or service center.
Air Filter Maintenance
Consult your dealer or service center when the (Filter) appears on the display of the wired remote controller.
Timer Remote Controller
Filter indicator
A
°
High-spec Wired
Remote Controller
Filter indicator
Wired Remote Controller
Filter indicator
01_320325_Eng.indb 7 2020/01/24 14:35:50

Related product manuals