Table of Contents
viii
High−level Instructions
Data transfer instructions
F0 MV 16-bit data move 3 − 8..........................................
P0 PMV
F1 DMV 32-bit data move 3 − 10........................................
P1 PDMV
F2 MV/ 16-bit data invert and move 3 − 12..............................
P2 PMV/
F3 DMV/ 32-bit data invert and move 3 − 14..............................
P3 PDMV/
F4 GETS Reading of head word No. of the specified slot. 3 − 16.............
P4 PGETS
F5 BTM Bit data move 3 − 17..........................................
P5 PBTM
F6 DGT Hexadecimal digit data move 3 − 21.............................
P6 PDGT
F7 MV2 Two 16-bit data move 3 − 25...................................
P7 PMV2
F8 DMV2 Two 32-bit data move 3 − 27...................................
P8 PDMV2
F10 BKMV Block move 3 − 29............................................
P10 PBKMV
F11 COPY Block copy 3 − 31.............................................
P11 PCOPY
F12 ICRD Data read from EEPROM 3 − 33................................
Data read from F−ROM 3 − 35..................................
F12 ICRD Data read from IC card 3 − 37..................................
P12 PICRD
P13 PICWT Data write to EEPROM 3 − 39..................................
Data write to F−ROM 3 − 41....................................
F13 ICWT Data write to IC card 3 − 43....................................
P13 PICWT
F14 PGRD Program read from IC card 3 − 45...............................
P14 PPGRD
F15 XCH 16-bit data exchange 3 − 49....................................
P15 PXCH
F16 DXCH 32-bit data exchange 3 − 51....................................
P16 PDXCH
F17 SWAP Higher/ lower byte in 16-bit data exchange 3 − 53.................
P17 PSWAP
F18 BXCH 16−bit blocked data exchange 3 − 55............................
P18 PBXCH
To Next Page
Loading...
