5-69
FP0R (A: Available, N/A: Not available)
Address Name Description
Read-
ing
Writ-
ing
DT90123 Not used - N/A N/A
DT90124
COM SEND/RECV
instruction end code
For details, refer to Programming Manual
(F145 and F146).
N/A N/A
DT90125 Not used - N/A N/A
DT90126
Forced ON/OFF
operating station
display
Used by the system N/A N/A
DT90127
to
DT90139
Not used - N/A N/A
DT90140
The number of times the receiving operation
is performed.
DT90141
The current interval between two receiving
operations: value in the register x 2.5ms
DT90142
The minimum inerval between two receiving
operations: value in the register x 2.5ms
DT90143
The maximum interval between two receiving
operations: value in the register x 2.5ms
DT90144
The number of times the sending operation is
performed.
DT90145
The current interval between two sending
operations: value in the register x 2.5ms
DT90146
The minimum interval between two sending
operations: value in the register x 2.5ms
DT90147
MEWNET-W0
PC(PLC) link 0 status
The maximum interval between two sending
operations: value in the register x 2.5ms
A N/A
DT90148
The number of times the receiving operation
is performed.
DT90149
The current interval between two receiving
operations: value in the register x 2.5ms
DT90150
The minimum inerval between two receiving
operations: value in the register x 2.5ms
DT90151
The maximum interval between two receiving
operations: value in the register x 2.5ms
DT90152
The number of times the sending operation is
performed.
DT90153
The current interval between two sending
operations: value in the register x 2.5ms
DT90154
The minimum interval between two sending
operations: value in the register x 2.5ms
DT90155
MEWNET-W0
PC(PLC) link 1 status
The maximum interval between two sending
operations: value in the register x 2.5ms
A N/A
DT90156
Area used for measurement of receiving
interval.
DT90157
MEWNET-W0
PC(PLC) link 0 status
Area used for measurement of sending
interval.
A N/A