5-86
WR902
Relay No. Name Description
R9020 RUN mode flag
Turns off while the mode selector is set to PROG.
Turns on while the mode selector is set to RUN.
R9021 Not used
R9022 Not used
R9023 Not used
R9024 Not used
R9025 Not used
R9026 Message flag Turns on while the F149 (MSG) instruction is executed.
R9027 Not used
R9028 Not used
R9029 Forcing flag
Turns on during forced on/off operation for input/output
relay timer/counter contacts.
R902A Interrupt enable flag
Turns on while the external interrupt trigger is enabled by
the ICTL instruction.
R902B Interrupt error flag Turns on when an interrupt error occurs.
R902C Sample point flag
Note)
Sampling by the instruction=0
Sampling at constant time intervals=1
R902D
Sample trace end flag
Note)
When the sampling operation stops=1,
When the sampling operation starts=0
R902E
Sampling stop trigger
flag
Note)
When the sampling stop trigger activates=1
When the sampling stop trigger stops=0
R902F
Sampling enable flag
Note)
When sampling starts=1
When sampling stops=0
Note) Available for the 32k type only.