EasyManua.ls Logo

Panasonic FP-E - Page 1266

Panasonic FP-E
1334 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-178
FP2/FP2SH/FP3/FP10SH (A: Available, N/A: Not available)
Address
FP3
FP2/
FP2SH
FP10SH
Name Descriptions
Read-
ing
Writ-
ing
DT9018 DT90018
Operation error
address
(non-hold)
The address whre an operation error
occurred is stored. Each time an error
occurs, the new address overwrites the
previous address. At the beginning of
scan, the addressis 0. Monitor the
address using decimal display.
(Reference: DT90258)
DT9019 DT90019
2.5 ms ring
counter
The data stored here is increased by one
very 2.5 ms (H0 to HFFFF)
Difference between the values of the two
points (absolute value) x 2.5 ms =
Elapsed time between the two points.
A N/A
DT9020 -
Maximu value of
program
(Available PLC:
FP3)
The last address of sequence program
area set in system register 0 is stored.
Display of
program
capacity
(Available PLC:
FP10SH)
The program capacity is stored in
decimal.
Example:
K30: approx. 30 K steps
K60: approx. 60 K steps (with memory
expansion)
- DT90020
Display of
program
capacity
(Available PLC:
FP2)
The program capacity is stored in
decimal.
Example:
K16: approx. 16 K steps (K15870)
K32: approx. 32 K steps (with memory
expansion)
DT9021
(*Note)
-
Maximum value
of file register
(Available PLC:
FP3)
The maximum (last) address of the file
registers available are stored in here.
-
DT90021
(*Note)
Maximum value
of file register
(Available PLC:
FP2/FP10SH)
The maximum (last) address of the file
registers available are stored in here.
N/A N/A
Note) Used by the system.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com