5-194
FP2/FP2SH/FP3/FP10SH (A: Available, N/A: Not available)
Address
FP3
FP2/
FP2SH
FP10SH
Name Descriptions
Read
-ing
Writ-
ing
DT9238 DT90238
Send WACK
DT9239 DT90239
Send WACK
DT9240 DT90240
Send answer
DT9241 DT90241
Send answer
DT9242 DT90242
Unidentified command
DT9243 DT90243
Counts how many times a parity error is
detected.
DT9244 DT90244
End code receiving error
DT9245 DT90245
Format error
DT9246 DT90246
Not support error
DT9247 DT90247
Self-diagnostic result
DT9248 DT90248
Counts how many times loop change is
detected.
Available PLC: FP3, FP10SH
DT9249 DT90249
Counts home many times link error is
detected.
DT9250 DT90250
Counts how many times main loop break is
detected.
Available PLC: FP3, FP10SH
DT9251 DT90251
Counts how many times sub loop break is
detected.
Available PLC: FP3, FP10SH
DT9252 DT90252
Loop reconstruction condition
Available PLC: FP3, FP10SH
DT9253 DT90253
Loop operation mode
Available PLC: FP3, FP10SH
DT9254 DT90254
MEWNET-
W/-P link
status
[W/P link 3]
(*Note)
Loop input status
Available PLC: FP3, FP10SH
A N/A
- DT90255
Monitoring
tool port
station No.
(Available
PLC: FP2SH/
FP10SH)
Station number BCD (H1 to H32) set for tool
port is stored here.
- DT90256
Monitoring
COM port
station No.
(Available
PLC: FP2SH/
FP10SH)
Station number BCD (H1 to H32) set for tool
port is stored here.
A N/A
Note) For MEWNET-W system, available PLC type: FP2/FP2SH/FP3/FP10SH
For MEWNET-P system, available PLC type: FP3/FP10SH