Basic Instructions
2 − 113
4
Specifying periodical interrupt programs (when S1 = H3 or S1=H5) for FP0/FP2/FP2SH/FP10SH only
Specify the setting with decimal number.
The time interval = value of S2 × 0.5 (ms).
Bit position
87 43 012 1115
. . .. .. ..
S2
K0 to K3000
Time interval setting: K1 to K3000 (0.5ms to 1.5s)
INT24 disabled: K0
Note
For the difference in the operation of H3 and H5, refer to
“Example 2 for setting periodical interrupt”.
(H5 can be specified with the PLC FP2/FP2SH Ver. 1.50 or later.)
FP2/FP2SH/FP10SH
To Next Page