High−level Instructions
3 − 353
(1) Specifying word unit transmission
If word unit transmission is being used, the data for the specified number of words is sent from the memory
area of the local station specified by S2, and is stored at the beginning of the memory area of the remote
station specified by D and N.
If only the MEWNET−H network is being used, up to 1,020 words can be sent at one time, and if the network is
using the MEWNET−P or MEWNET−W, up to 16 words can be sent at one time.
15
Number of transmission words: H001 to H3FC (1 to 1020)
Specifies H0.
S1:
11 7 4 0
Example:
If 10 words of data are being sent, K10(H000A) should be
specified in S1.
(2) Specifying bit unit transmission
If bit unit transmission is being used, the information of the specified bit in the memory area of the local station
specified by S2 is sent to the specified bit of the memory area of the remote station specified by D and N.
1115
Bit No. of local station: H0 to HF(0 to 15)
Specifies H8
S1:
740
Specifies H0
Bit No. of remote station: H0 to HF(0 to 15)
Example:
If the data of Bit No. 15 of the local station memory area is
being sent to Bit No. 0 of the memory area in the remote
station, H800F should be specified in S1.
(3) Specifying the remote station (common to both word/bit transmission)
15
Unit No.: H01 to H40 (0 to 64)
Specifies H0.
S1+1:
11 7 4 0
Route No.: H1 to H8(1 to 8)
The unit number should be converted to a hexadecimal number and specified.
− For MEWNET−W: H01 to H20 (1 to 32)
− For MEWNET−P: H01 to H3F (1 to 63)
− For MEWNET−H: H01 to H40 (1 to 64)
To Next Page