High−level Instructions
3 − 385
Additional information concerning the F146 (RECV) instruction
Receiving the special data registers and special internal relays using the data transfer instruction
Special data registers and special internal relays cannot be transferred using the F146 (RECV) instruction.
Use a program like that shown below to receive these types of data.
Receiving special data registers in the FP2 , FP2SH or FP10SH (source issuing the command:
FP2/FP2SH/FP10SH)
X10
F146 RECV, S, DT90000, Kn, DT0
10
Receiving special internal relays (source issuing the command: FP2/FP2SH/FP10SH)
X10
F146 RECV, S, WR900, Kn, DT0
10
How to receive FL (How to specify FL banks)
How to specify the FL bank for destination units
The FL to communicate is specified like FL0 + H10. Specify FL1 + H10 to specify the FL of the bank 1
(FL2 + H10 for the bank 2)
How to specify the FL bank for a local unit
Normally, FLn is specified for the FL for the local unit. If specifying, the FL will be received at the FL
bank which has been selected in the execution of this instruction.
To Next Page