High−level Instructions
3 − 418
Flag conditions
・Error flag (R9007): Turns on and stays on when:
・Error flag (R9008): Turns on for an instant when:
− The area specified using the index modifier exceeds the limit.
− The data specified by S1 and S2 is not BCD data.
− The data specified by S1 is not the date/clock data.
− The data specified by S2 is not the time data.
− The specified data exceeds tha area.
Precautions during programming
The special data registers DT9054 to DT9056/DT90054 to DT90056 in which the values of the internal
calendar timer are stored, cannot be specified directly for D. To change the value of the internal calendar
timer, store the subtraction results in a separate memory area, and then use the F0 (MV) instruction to transfer
the value to DT9054 to DT9056/DT90054 to DT90056.
Data configuration for the internal calendar timer
DT90056
DT90055 DT90054
Years Months Days Hours Minutes Seconds
FP2/FP2SH/FP10SH
To Next Page