1.3 Explanation of Memory Areas
1-53
Available range of link data registers
The available range of link data registers varies depending on the type of network and
the combination of units. The available range and number of points must be specified
separately for each network.
For MEWNET−W and MEWNET−P:
A maximum of 128 words can be used with one link unit. The available range is from
LD0 to LD127 for the first unit (PC Link 0), and from LD128 to LD255 for the second unit
(PC Link 1).
For MEWNET−W2:
A maximum of 4,096 words can be used per link unit. Please set the range of use at the
MEWNET−W2 settings menu.
With the FP2SH, the range between LD0 and LD8447 can be specified. When used
with MEWNET−W the range between LD0 and LD255 cannot be used.
With the FP2, the range between LD0 and LD255 can be specified. Also, the data
register can be used in place of the link relay by setting the MEWNET−W2 setting menu.
However, when used with MEWNET−W the range between LD0 and LD255 cannot be
used with MEWNET−W2.
For MEWNET−H:
A maximum of 8,192 words can be used. Please set the range to be used with the
MEWNET−H link setting software.
With the FP10SH, the range from LD0 to LD8447 can be used.
If used in conjunction with a MEWNET−W or MEWNET−P link unit, be aware that the
range from LD0 to LD255 cannot be used.
To Next Page
Loading...
