High−level Instructions
3 − 515
Flag conditions
・Error flag (R9007):
・Error flag (R9008):
− Turns on when the area specified using the index modifier exceeds the limit.
− Turns on when n is out of the specified range.
− Turns on when each data of [S,S+1] to [S+4,S+5] is out of the specified
range.
− Turns on when [S+2,S+3]>[S+4,S+5].
− Turns on when [S+10,S+11] is out of the specified range.
− Turns on when the pulse output has not been set by the system register.
− Turns on when the interrupt execution has been specified for executing the
instruction in the main program.
FP0R
To Next Page