1.3 Explanation of Memory Areas
1-63
The following index modifications are possible
Memory area numbers used with high-level instructions
K constants (16-bit and 32-bit) and H constants (16-bit and 32-bit) specified with
high-level instructions
Relay numbers used with the following basic instructions: ST, ST/ , AN, AN/, OR, OR/,
OT, KP, SET, RST, OT↑, OT↓
Instruction numbers specified with the following basic instructions: TM, CT, MC, MCE,
JP, LOOP, CALL, FCAL (FCAL instruction can be used with the FP2SH/FP10SH.)
Memory areas used with the following basic instructions: TM, CT, SR
Note
There are some cases in which index modification cannot be
specified, depending on the instruction. Confirm the table of
“Operands” on the page describing the various instructions.
To Next Page
Loading...
