High−level Instructions
3 − 616
How data tables are set
Specify the values for the character string size and number of characters. The F0 (MV) instruction is used to
specify values.
Specify the characters. The F95 (ASC) instruction is used to specify characters.
Example:
The example shows (character string size “16 characters”, “no
specification of characters”) for DT0.
F0(MV) , K16, DT0
R0
Character string size
Example:
The example shows a data table specifying the following for
DT0: (character string size “20 characters”, number of
characters “12 characters”, and character data
“ABCDEFGHIJKL”).
R0
F0(MV), K20, DT0
Character string size
(20 characters)
Number of characters
(12 characters)
Character data
F0(MV), K12, DT1
F95 ASC, M ABCDEFGHIJKL, DT2
To Next Page