High−level Instructions
3 − 642
If S2 specifies a higher word of double word data, processing will take place over the same area as if the lower
word had been specified.
S1:
S1+1:
0
1
S2−1:
D:
D+1:
S1+2:
S1+3:
S2:
D+2:
Double word data table
n
Relative address
Minimum value
Lower word
Higher word
Relative address
Lower word
Higher word
Lower word
Higher word
If there are several values which are a minimum value, the relative address of the first value found searching
from S1 is stored in D+2.
Precaution during programming
Even if D+2 overflows the selected area, it will still be stored, and this may corrupt the data in the leading part
of the other area. (An area overflow check is not performed.)
Flag conditions
・Error flag (R9007): Turns on and stays on when:
・Error flag (R9008): Turns on for an instant when:
− The area specified using the index modifier exceeds the limit.
− S1 > S2.
− The areas of S1 and S2 are different.
To Next Page