1.3 Explanation of Memory Areas
1-69
Modifying instruction numbers of basic instructions
Timer numbers
Modifying TML20 −−− TML I020
Counter numbers
Modifying CT3000 −−− CT I03000
Shift register numbers
Modifying SRWR0 −−− SR I0WR0
Master control numbers
Modifying MCE1 −−− MCE I01
Label number specification with the Jump instruction
Modifying JP1 −−− JP I01
Label number specification with the Loop instruction
Modifying LOOP5 −−− LOOP I05
Subroutine program numbers
Modifying CALL10 −−− CALL I010
Note
Timer numbers and counter numbers can be modified only when
a memory area is specified for the set value.
TMXI0 0, SV0
Specification of set
value area number
Correct
Modification cannot be done if the set value is specified with a
constant.
TMXI0 0, K30
Specification of constant
Incorrect
To Next Page
Loading...
