Using a cloth dampened with kitchen detergent, remove any dirt from fan body. Wipe dry with a clean cloth.
Reinstall grille after finishing.
Routine maintenance must be done every
year. Please wear gloves during the
cleaning work.
Disconnect power supply before working on unit.
Do not immerse motor in water when
cleaning. Do not soak resin parts in
water over 140 °F (60 °C).
Never use gasoline, benzene, thinner or
any other such chemicals for cleaning the
ventilating fan.
Remove grille by pulling down one mounting spring.
Remove dust and dirt from fan body using a vacuum cleaner.
NOTE : The grille should be dry after cleaning.
1
2
3
2
Remove grille
1
Gloves
Slot
Grille
Mounting spring
Clean grille. (Don’t put into hot water. Use non-abrasive kitchen detergent, wipe dry with clean cloth.)
1
1
3
2
Maintenance of unit
Disconnect the wire from the receptacle, then pull down the other mounting spring.
Gloves
Drywall
Vacuum
cleaner
Gloves
Drywall
MAINTENANCE (CLEANING)
2
1
2
Grille
LED lamp wire
Receptacle
Drywall
Glove
Mounting spring
Insert the mounting springs into the slot as
shown to mount grille to fan body.
Connect the LED lamp wire to fan body.
Install grille
1
11
English
INSTALLATION (NEW CONSTRUCTION) CONTINUED
Mounting spring
Drywall
LED lamp wire
Receptacle
2
To Next Page
Loading...
