Cradle
You can use an optional cradle. This device freesyou from being bothered by a lot of cable connectionswhen you carry the computer. It also allows you to
connect various peripherals.
Connect the cradle to the expansion bus connector (A) on the bottom side of the computer.
For further information, refer to the instruction manual of the cradle.
CAUTION
n Connect or disconnect the cradle while the computer power is turned off.
n To boot the computer from a USB opticaldrive, be sure to connect the USB drive to the USB port on the computer, not to the USB port on the
cradle.
- 105 -
To Next Page
Loading...
