Wireless LAN
<Only for model with wireless LAN>
CAUTION
n Do not use wireless LAN on airplanes, in hospitals, or in other locations where wireless LAN signals may affect devices.
Follow the instructions of airline companies and hospitals. If you use the computer in these locations, turn off the wireless LAN.
n To avoid unauthorized access to the computer through wireless LAN
We recommend you to make securitysettingssuch as encryption before using wireless LAN.
Otherwise the disk data such as the shared filescan be exposed to the risk of unauthorized access.
N O T E
n Communication is established through the wireless LAN antenna (A). Do not block the antenna area with your hand or body.
n The transmission rate will be lower when a microwave oven is used near by.
n To use wireless LAN, set [Wireless LAN] of [Wireless Configuration] to [Enabled] (default) in the [Advanced] menu of the Setup Utility.
Using the Wireless LAN Function
Before using a wireless LAN, turn the wireless LAN communication on.
Turning on/off the wireless LAN communication
1.
To enable the wireless communication ( Disabling/Enabling Wireless Communication).
Setting the wireless LAN access point
Preparation
Follow the instruction manualof the wireless LAN access point to make settings for the access point to recognize the computer.
1. Turn the wireless LAN on.
2.
Touch or on the task tray.
3. Select an access point, and touch [Connect].
4. Input the key you set for the access point to recognize the computer, and touch [Next].
Wait for the computer to connect to the wireless LAN accesspoint.
When the icon on the notification area ischanged to , the wireless LAN setting is complete.
N O T E
- 47 -
To Next Page
Loading...
