Wireless WAN
<Only for model with wireless WAN>
N O T E
n Communication is established through the Wireless WAN antenna (A). Do not block the antenna area with your hand or body.
n To use wireless WAN, set [Wireless WAN] of [Wireless Configuration] to [Enabled] (default) in the [Advanced] menu of the Setup Utility.
n If “Device driver software was not installed correctly.” (or a similar message) appears when starting the computer or resuming from
sleep or hibernation.
When communication works normally, Wireless WAN isoperating correctly.
If communication fails, the device may not be recognized correctly. In thiscase, restart the computer.
n Do not use the nanoSIM card adapter.
n Do not insert nanoSIM cards on which labels or stickers are affixed. Failure to obey may result in malfunction.
Inserting/Removing a nanoSIM Card
Before using the Wireless WAN, set a nanoSIM card to the nanoSIM card slot.
CAUTION
n Be sure to turn off the computer before inserting or removing the nanoSIM card.
To insert a nanoSIM card
1. Turn off the computer and disconnect the AC adaptor.
2. Turn over the computer
Make sure no foreign objects are under the computer.
3.
Remove the battery pack ( Replacing the Battery Pack).
4. <Only for model with Built-in Bridge Battery>
Wait for about 3 minutes.
- 50 -
To Next Page
Loading...
