Panasonic FZ-G1 Series - Page 51

5. Remove the screws (A) and the nanoSIM card slot cover (B).
6. Insert the nanoSIM card (C) into the nanoSIM card slot with the contact side (D) facing downward and with the cut corner oriented as
shown in the illustration.
CAUTION
n Do not insert the nanoSIM card upside down.
7. Close the nanoSIM card slot cover(B), attach it and tighten the screw (A) firmly.
If the cover is not closed, the nanoSIM card may jump out when the computer falls.
8. Insert the battery pack and connect the AC adaptor.
To remove a nanoSIM card
1. Turn off the computer and disconnect the AC adaptor.
2. Turn over the computer
Make sure no foreign objects are under the computer.
3. Disconnect the AC adaptor, remove the battery pack.
4. <Only for model with Built-in Bridge Battery>
Wait for about 3 minutes.
5. Remove the screws (E) and the nanoSIM card slot cover (F).
6. Push the card.
It willcome out of the slot a little bit.
- 51 -