n Change the display mode to the landscape before starting screen calibration. If calibration is performed other than the landscape, it
may not be possible to touch the target marks correctly.
N O T E
n At first, sign in to Windows asan administrator, and perform this calibration.
1.
Set the touch screen mode to [Touch]. ( Touch Screen Mode)
2. Open the Control Panel, and then touch [Hardware and Sound] - [Tablet PC Settings].
3. Touch [Reset].
If you cannot touch [Reset], perform the following step 4.
Reset the calibration data.
1. At the confirmation message, touch [Yes].
2. Touch reset the data of [Touch input] or [Pen input].
N O T E
n We recommend using [Touch input] at the factory default.
4. Touch [Calibrate].
If [User Account Control] is displayed, touch [Yes].
5. Touch [Pen input] for the pen (includes) or [Touch input] for your finger.
6. Using the pen (included) or finger, touch each of the “+” target marks one by one, and then touch [Yes].
N O T E
n Make sure digitizer pen (included) is perpendicular to the screen to get the most accurate calibration.
CAUTION
n If you perform calibration as a standard user, the calibration data is valid untilyou sign out (the data becomes invalid after you have signed out).
When using the computer continuously, perform calibration as an administrator.
n If you cannot operate the computer correctlyafter calibration, delete the calibration data by touching [Control Panel] - [Hardware and Sound] -
[Tablet PC Settings] - [Reset], and perform calibration again. (Be sure to delete the calibration data as an administrator.)
N O T E
n The following message, “Right-click anywhere on the screen to return to the last calibration point. Press the Esc button to close the
tool.” will appear on the center of the screen during calibration. However, the operation to close the tool by pressing the ≪ Esc≫ key
can be performed only when an external keyboard is connected.
n If you cannot touch the desired position, perform calibration again and restart the computer.
- 20 -
To Next Page
Loading...
