Handling the screen
Do not applystrong pressure to the screen outside of the LCD display.
Applying strong pressure to the screen outside of the display area may result in malfunctions or damage to the LCD screen.
Do not applyexcessive force to the screen.
Do not place any objectson the LCD screen. Any of the above may cause the screen glass to break, or may damage the LCD screen.
Operation response may be slower in low temperature environments.
The screen mayrespond to operations more slowly when using the computer in temperatures less than 5 °C {41°F}, but this is not a malfunction.
Response time will return to normalwhen the computer is returned to room temperature.
If the pointer jumps to a location other than where the screen was touched, or if the LCD resolution changes, recalibrate the screen.
Perform the procedure of “Calibrating the Screen”.
Handling the digitizer pen (included)
Clean the digitizer pen tip and screen prior to operation.
Foreign particles can scratch the screen and impede the operation of the digitizer pen (included).
Use onlythe digitizer pen to touch the screen.
Using it for any other purpose may damage the digitizer pen and result in scratcheson the screen.
The pointer cannot follow the digitizer pen movement if you move the digitizer pen too quickly.
Do not applyexcessive force to the tip of digitizer pen.
The tip of the digitizer pen (A) isequipped with a sensor. Continued applied pressure to the tip may result in its malfunction or degradation. Make
sure excessive pressure isnot applied to the tip when storing the digitizer pen.
The digitizer useselectromagneticinduction and may not work properlynear strong electricalfield or magnetic field.
such as:
Near AM radio base station or relay station antennas
Near CRT displays that generate strong electromagnetic field noise
Move the digitizer away from such locations so it willwork properly.
When using peripheral devices
Follow these instructions and this Manual to avoid any damage to the devices. Carefully read the instruction manuals of the peripheral devices.
Use the peripheraldevices conforming to the computer’sspecifications.
Connect to the connectors in the correct direction.
If it is hard to insert, do not try forcibly but check the connector’s shape, direction, alignment of pins, etc.
If screwsare included, fasten them securely.
Remove the cables when you carry the computer. Do not pull the cablesforcibly.
Preventing your computer from unauthorized use via wireless LAN/Bluetooth/wireless WAN
<Only for modelwith wireless LAN/Bluetooth/wireless WAN>
Before using wireless LAN/Bluetooth/wireless WAN, make the appropriate securitysettings such asdata encryption.
Battery Recalibration
The battery recalibration may take a long time due to the large battery capacity. This is not a malfunction.
- 77 -
To Next Page
Loading...
