- 50 -
In Motion Picture Recording Mode, you can further improve optical image stabilization
by touching and holding . With this function, you can further reduce the effects of
the shake that tends to occur when using zoom.
1 Press the Optical Image Stabilizer button to turn the image stabilizer on.
2 Touch and hold .
≥ Icon is displayed in A while you are touching and holding .
≥ Optical Image Stabilizer Lock is released when you remove your finger from the icon.
∫ To make the display of disappear
Display of will not disappear even when no operation is performed for specific time with
the default setting. To make the display of disappear, change the setting of the
[O.I.S. LOCK DISPLAY].
≥ Stabilization may not be possible under strong shaking conditions.
≥ To record while moving the unit quickly, release Optical Image Stabilizer Lock.
It is possible to focus and record a still picture of a subject that is touched.
1Touch .
2 Touch the subject.
≥ Focus area will display to the touched position, and a
still picture is recorded.
≥ Depending on the recording conditions or recognition of the touched position, it may not be
possible to record the intended picture.
≥ This will not operate for recording yourself.
Optical Image Stabilizer Lock
: [SETUP] # [O.I.S. LOCK DISPLAY] # desired setting
[ON]: Constantly display.
[OFF]: The icon will disappear after approx. 5 seconds without any touch operation.
Touch Shutter
To Next Page
Loading...
