47
VQT4C76
Please refer to page 52.
The recording lamp lights up during recording and flashes when the unit receives a signal
from the remote control or when the Self-timer is counting down.
The recording lamp lights up during recording and flashes when the Self-timer is counting
down.
When this is set to [OFF], it does not light during recording.
Touch screen operation, starting and stopping of recording and unit on/off can be confirmed
with this sound.
2 Beeps for 4 times
When an error occurs, follow the instructions displayed on the screen. (l 150)
You can change the operation icons displayed in the Touch Menu.
Register 3 favorite operation icons.
≥ This function’s default settings are (Fade), (PRE-REC) and (Backlight
Compensation) for Motion Picture Recording Mode, and (Built-in flash),
(Self-timer) and (Backlight Compensation) for Still Picture Recording Mode.
1 Touch [SELECT OPERATION ICONS].
2 Touch the operation icon you would like to change to cancel the setting.
3 Touch the operation icon to be set.
≥ Name of the function is displayed by touching and holding on the operation icon.
≥ To cancel, touch the operation icon again.
4 Touch [ENTER].
≥ For details about the function of each operation icon, refer to page 60.
[REMOTE CONTROL]
[ON]/[OFF]
[REC LAMP]
[ON]/[OFF]
[ALERT SOUND]
/ /[OFF]
(Volume low)/ (Volume high)
[SELECT OPERATION
ICONS]
HC-X900M
HC-X800
HC-X900M&X800P&PC&PU-VQT4C76_mst.book 47 ページ ２０１２年１月１１日 水曜日 午後１０時６分
To Next Page
Loading...
