- 130 -
∫ Dubbing using equipment without an SD card slot or a USB terminal,
or using a video device
You can dub by connecting an AV multi cable.
≥ Images are dubbed in standard quality.
≥ Use the AC adaptor to free you from worrying about the battery running down.
≥ Change the mode to
.
1 Connect this unit to a video device and then start playback on this
unit.
2 Start recording on the connected device.
≥ To stop recording (dubbing), stop playback on this unit after stopping recording on the
recorder.
≥ If the date and time display and function indication are not wanted, cancel them before
dubbing. (l 35, 105)
≥ For setting when connecting the AV multi cable, refer to page 106.
Dubbing in standard picture quality
Change the video input on
the video device and TV
that this unit is connected
to.
≥ The channel set will differ
depending on the terminal to
which the unit is connected.
≥ See the operating instructions of
the video device for details.
≥ Insert the plugs as far as they will
go.
≥ Do not use any other AV multi
cables except the supplied one.
A AV multi cable (supplied)
If the dubbed images are played back on a wide-screen TV, the images may be stretched
vertically.
In this case, refer to the operating instruction for the device you are connecting to or read
the operating instructions of the wide-screen TV and set the aspect ratio to 16:9.
AV MULTI
HC-X900&X900M&X800EP-VQT4D01_mst.book 130 ページ ２０１２年１月１２日 木曜日 午前１０時４４分
To Next Page
Loading...
