Panasonic HC-X920 - Inserting;Removing an SD Card

- 14 -
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1 Open the SD card cover and insert
(remove) the SD card into (from)
the card slot.
≥ Face the label side B in the direction shown
in the illustration and press it straight in as far
as it will go.
≥ Press the centre of the SD card and then pull
it straight out.
2 Press the C part
of the SD card
cover and close
the SD card cover.
≥ Securely close it until it
clicks.
≥ Do not touch the terminals on the back of the
SD card.
≥ Do not apply strong shocks, bend, or drop the
SD card.
≥ Electrical noise, static electricity or the failure
of this unit or the SD card may damage or
erase the data stored on the SD card.
≥ When the card access lamp is lit, do not:
j Remove the SD card
j Turn the unit off
j Insert and remove the USB cable
j Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or this
unit.
≥ Do not expose the terminals of the SD card to
water, dirt or dust.
≥ Do not place SD cards in the following areas:
j In direct sunlight
j In very dusty or humid areas
j Near a heater
j Locations susceptible to significant
difference in temperature (condensation
can occur.)
j Where static electricity or electromagnetic
waves occur
≥ To protect SD cards, return them to their
cases when you are not using them.
≥ About disposing of or giving away the SD
card. (l 195)
When using an SD card not from Panasonic, or one previously used on other equipment, for the
first time on this unit, format the SD card. (l 41) When the SD card is formatted, all of the
recorded data is deleted. Once the data is deleted, it cannot be restored.
Access lamp [ACCESS] A
≥ When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
