72
VQT3K80
This will reduce the wind noise coming into the built-in microphones while maintaining the
realism.
≥ Switch to manual mode. (l 80)
≥ This function’s default setting is [ON].
≥ When switching to intelligent auto mode, [WIND NOISE CANCELLER] is set to [ON], and
the setting cannot be changed.
≥ You may not see the full effect depending on the recording conditions.
≥ If wind sound cannot be reduced with the wind noise canceller function alone, set [BASS
SETTING] to [LOWCUT]. (l 74)
Recording setting of the built-in microphone can be adjusted.
≥ Switch to manual mode. (l 80)
≥ If you wish to record higher quality sound and maintain realism even when zooming in, for
instance recording a music recital, we recommend setting [MIC SETUP] to [SURROUND].
≥ If you have an external microphone connected when recording in [iFrame], [MIC SETUP] is
set to [STEREO MIC] automatically.
[WIND NOISE CANCELLER]
: [RECORD SETUP] # [WIND NOISE CANCELLER] # [ON]
[MIC SETUP]
: [RECORD SETUP] # [MIC SETUP] # desired setting
[SURROUND]: Sound is recorded with 5.1 ch surround microphone.
[ZOOM MIC]: Directivity of the microphone is interlocked with the zoom
operation. Sounds near the front of the unit are recorded more
clearly if you zoom in (close-up) and surrounding sounds are
recorded more realistically if you zoom out (wide angle).
[FOCUS MIC]: Directivity of the centre is enhanced for recording audio near the
front of the unit more clearly.
[STEREO MIC]: Sound from two directions is recorded in 2 ch by forward-facing
stereo microphones.
MENU
MENU
HDC-SD900&TM900&HS900EB-VQT3K80_eng.book 72 ページ ２０１０年１２月２９日 水曜日 午後２時５０分
To Next Page
Loading...
