Panasonic HDC-SD900 - Page 44

44
VQT3K80
Please refer to page 49.
The recording lamp lights up during recording and flashes when the unit receives a signal
from the remote control or when the self-timer is counting down. When this is set to [OFF], it
does not light during recording.
Touch screen operation, start and stop of recording and unit on/off can be confirmed with this
sound.
(Volume low)/ (Volume high)
2 Beeps for 4 times
When an error occurs. Check the sentence displayed on the screen. (l 142)
This makes it easier to view the LCD monitor in bright places including outdoors.
≥ These settings will not affect the images actually recorded.
≥ It is possible to set from the quick menu. (l 40)
(Makes even brighter)/ (Makes brighter)/ (Normal)/ (Makes less bright)/
*(Automatic adjustment)
* It is not displayed in the manual mode or in the playback mode.
≥ When the AC adaptor is in use, the LCD monitor is set to automatically.
≥ When the LCD monitor is bright, the recordable time with the battery will be shorter.
It adjusts brightness and colour density on the LCD monitor.
≥ These settings will not affect the images actually recorded.
1 Touch [LCD SET].
2 Touch the desired setting item.
[BRIGHTNESS]:
Brightness of the LCD monitor
[COLOUR]:
Colour level of the LCD monitor
3 Touch / to adjust settings.
4 Touch [ENTER].
≥ Touch [EXIT] to exit the menu screen.
[REMOTE CONTROL]
[OFF]/[ON]
[REC LAMP]
[OFF]/[ON]
[ALERT SOUND]
[OFF]/ /
[POWER LCD]
////
[LCD SET]
+2
+1
0
- 1
A
+2
+1
0
- 1
A
+1
HDC-SD900&TM900&HS900EB-VQT3K80_eng.book 44 ページ ２０１０年１２月２９日 水曜日 午後２時５０分