110
VQT2D32
With a PC
Setup
2
Connecting to a PC
≥ Connect this unit to the PC after the software applications are installed.
≥ Remove the supplied CD-ROM from your PC.
A USB cable (supplied)
1 Connect this unit to the AC
adaptor.
≥ It is possible to use it connected to the PC with
the batteries only.
2 Turn on the unit.
≥ This function is available in all modes.
3 Connect this unit to a PC.
The USB function selection screen will appear.
≥ Insert the USB connectors as far as they will
go.
≥ Do not use any other USB cables except the
supplied one. (Operation is not guaranteed
with any other USB cables.)
4 Touch [PC].
≥ The Smart wizard screen is automatically
displayed when HD Writer AE 1.5 is installed.
≥ This unit is automatically recognised as an
external drive of the PC. (l 112)
≥ When you select an option other than [PC],
reconnect the USB cable.
≥ When the unit is connected to a PC its
power cannot be turned off.
Disconnect the USB cable, before turning
this unit off.
≥ Do not disconnect the USB cable or the AC
adaptor while the access lamp is on or card
access icon ( ) appears on the unit screen.
≥
Do not disconnect the USB cable or the AC
adaptor while the access lamp is on or Built-in
memory access icon ( ) appears on the unit
screen.
To Next Page
Loading...
